USPSA, WAC, 8-7-18

Open Division

Shooting the Open Edge in .40SW using 155gr BB RN loads.

Stage 2

From the left, start on the far target, then the one up close while leaving.
Run right, then while getting into position, the first one on the right, then the one to its left. The second looked off so I make it up (didn’t need it). Swing all the way left for the one with the no-shoot.
Run down to my index (gap on the right fault line), then pause for the one through the port.
Cut right off bounds, then back in for the remaining targets right to left.
Clean. 13th out of 43.

Stage 3

Start looks similar to the previous, with one up close and one all the way back. Since we were starting from the start stick all the way to the right, I reverse the order and take the one up close while ‘landing’.
Go all the way right, pause for the one on the left, then move up along the line, taking the 2 on the right up close on the move.
Finish on the remaining paper.
Clean; 11th.
The plan was copied after watching other shooters and seeing better positions from my original plan.

Stage 4

Stage 1

Start on the right for all the steel. I did this so if I made makeups, I knew to reload in between.
Step left for the middle right array.
Go all the way left but start on the middle left array and hard lean on the left most.
Finish on the left array.
Clean again, 9th.

The Good

Clean!
Steel 1 for 1
Stage planning and copying (stage 3)
Gun ran 100%
Running around ok now.
Keeping shooting on the move to retreats and landings (while getting into position).

Needs Improvement

FInished 8th out of 43 overall and 2nd out of 5 in Open.

Posted by jaranieg

Filed in USPSA/IPSC

Pinoy 3Gunner's Blog